??? 08/18/13 00:22 Read: times |
#189997 - STC Responding to: ???'s previous message |
Found another option - the STC15F104E. When running the software at 5.53MHz, it consumes 1.13mA. Not quite as good as the 0.6mA of the AT89LP52, but much better than the AT89LP214. The STC runs at three times the clock of the LP52, so the output timing precision is improved, so it may be the best choice in the end...
Mikkel |
Topic | Author | Date |
Low-power MCU needed | 01/01/70 00:00 | |
OK, but wrong | 01/01/70 00:00 | |
Wrong how? | 01/01/70 00:00 | |
Silabs options | 01/01/70 00:00 | |
C8051F99x | 01/01/70 00:00 | |
Silabs | 01/01/70 00:00 | |
look it up | 01/01/70 00:00 | |
Looked up | 01/01/70 00:00 | |
f53, no | 01/01/70 00:00 | |
C8051F537A is OK | 01/01/70 00:00 | |
the current in active mode is not the issue | 01/01/70 00:00 | |
Inactive current | 01/01/70 00:00 | |
re: wrong | 01/01/70 00:00 | |
Consumers | 01/01/70 00:00 | |
Zilog Z51F0410 | 01/01/70 00:00 | |
Zilog | 01/01/70 00:00 | |
Check you are entering idle ? | 01/01/70 00:00 | |
idle current | 01/01/70 00:00 | |
Idle test | 01/01/70 00:00 | |
re: | 01/01/70 00:00 | |
It floats! It floats! | 01/01/70 00:00 | |
re:floats | 01/01/70 00:00 | |
re:floats | 01/01/70 00:00 | |
Timers | 01/01/70 00:00 | |
More idle tests | 01/01/70 00:00 | |
Better regulator? | 01/01/70 00:00 | |
LR8K4 450V regulator | 01/01/70 00:00 | |
also try CLKREG | 01/01/70 00:00 | |
Clk Dividers are a good idea | 01/01/70 00:00 | |
No dividers | 01/01/70 00:00 | |
LP52 is cheaper too... | 01/01/70 00:00 | |
LP52 | 01/01/70 00:00 | |
No GND pin? | 01/01/70 00:00 | |
re:idle | 01/01/70 00:00 | |
Totally idle | 01/01/70 00:00 | |
Checks | 01/01/70 00:00 | |
More checks | 01/01/70 00:00 | |
Power Down ? | 01/01/70 00:00 | |
test setup | 01/01/70 00:00 | |
STC | 01/01/70 00:00 | |
C8051F86x/85x ? | 01/01/70 00:00 | |
Maybe not such a good choice, after all? | 01/01/70 00:00 | |
Support? | 01/01/70 00:00 | |
'51 support | 01/01/70 00:00 |