??? 06/11/13 22:33 Read: times |
#189921 - Checks Responding to: ???'s previous message |
Mikkel C. Simonsen said:
I have just tried code that does not turn on the timer - it just sets PCON = 1. The current stays at 2.4/2.5mA. I tried using an external 4MHz oscillator also - slightly more current than with the 2MHz resonator. The idle current should be 1mA using a 4MHz external clock, according to the datasheet...
Was that a CMOS drive Osc ? What is Icc in Idle, with XTAL1 pin held H/L ? To be certain you are in idle, put a loop that toggles a pin after the IDLE, and a line that clears another pin, just before you hit idle. The earlier pin should be low and following pin should be static. It may 'get in' one toggle, depending on the code flow. |
Topic | Author | Date |
Low-power MCU needed | 01/01/70 00:00 | |
OK, but wrong | 01/01/70 00:00 | |
Wrong how? | 01/01/70 00:00 | |
Silabs options | 01/01/70 00:00 | |
C8051F99x | 01/01/70 00:00 | |
Silabs | 01/01/70 00:00 | |
look it up | 01/01/70 00:00 | |
Looked up | 01/01/70 00:00 | |
f53, no | 01/01/70 00:00 | |
C8051F537A is OK | 01/01/70 00:00 | |
the current in active mode is not the issue | 01/01/70 00:00 | |
Inactive current | 01/01/70 00:00 | |
re: wrong | 01/01/70 00:00 | |
Consumers | 01/01/70 00:00 | |
Zilog Z51F0410 | 01/01/70 00:00 | |
Zilog | 01/01/70 00:00 | |
Check you are entering idle ? | 01/01/70 00:00 | |
idle current | 01/01/70 00:00 | |
Idle test | 01/01/70 00:00 | |
re: | 01/01/70 00:00 | |
It floats! It floats! | 01/01/70 00:00 | |
re:floats | 01/01/70 00:00 | |
re:floats | 01/01/70 00:00 | |
Timers | 01/01/70 00:00 | |
More idle tests | 01/01/70 00:00 | |
Better regulator? | 01/01/70 00:00 | |
LR8K4 450V regulator | 01/01/70 00:00 | |
also try CLKREG | 01/01/70 00:00 | |
Clk Dividers are a good idea | 01/01/70 00:00 | |
No dividers | 01/01/70 00:00 | |
LP52 is cheaper too... | 01/01/70 00:00 | |
LP52 | 01/01/70 00:00 | |
No GND pin? | 01/01/70 00:00 | |
re:idle | 01/01/70 00:00 | |
Totally idle | 01/01/70 00:00 | |
Checks | 01/01/70 00:00 | |
More checks | 01/01/70 00:00 | |
Power Down ? | 01/01/70 00:00 | |
test setup | 01/01/70 00:00 | |
STC | 01/01/70 00:00 | |
C8051F86x/85x ? | 01/01/70 00:00 | |
Maybe not such a good choice, after all? | 01/01/70 00:00 | |
Support? | 01/01/70 00:00 | |
'51 support | 01/01/70 00:00 |