Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
10/15/10 22:42
Read: times


 		 #179131 - Agree
Responding to: ???'s previous message
Richard Erlacher said:
it appeared to me that O/P was confusing interface voltage levels with supply voltage.

I agree.

List of 45 messages in thread
TopicAuthorDate
JHD162A lcd            01/01/70 00:00      
   5V LCD            01/01/70 00:00      
      in addition !            01/01/70 00:00      
         Matching output voltages with input requirements            01/01/70 00:00      
         C8051F120 has 5V tolerant Input/Output pins            01/01/70 00:00      
            Yes i have...            01/01/70 00:00      
            careful            01/01/70 00:00      
               what are...            01/01/70 00:00      
                  Powered components            01/01/70 00:00      
                     Thank You            01/01/70 00:00      
                  examples            01/01/70 00:00      
               active level converters            01/01/70 00:00      
                  Resistors not good way to reduce voltage            01/01/70 00:00      
                     Thank You...            01/01/70 00:00      
                     Per forgot one thing            01/01/70 00:00      
                        R*C            01/01/70 00:00      
                           delay            01/01/70 00:00      
            5V and micro and LCD            01/01/70 00:00      
   potentiometer            01/01/70 00:00      
      Film Capacitor??            01/01/70 00:00      
         thank you so much            01/01/70 00:00      
      SIL resistor            01/01/70 00:00      
         new delhi            01/01/70 00:00      
            Actually, it seems that they *do* know!            01/01/70 00:00      
         SIL Residtor *network*            01/01/70 00:00      
            correction...Yes they do know            01/01/70 00:00      
   Port I/O pin voltage            01/01/70 00:00      
      "5V-Tolerant" pins - already answered            01/01/70 00:00      
      5V tolerant, not 5V            01/01/70 00:00      
         Thank You            01/01/70 00:00      
            Maybe you can "get by" with this ...            01/01/70 00:00      
               "Absolute Maximum Limits" are not Operating conditions            01/01/70 00:00      
                  That's true, it's an absolute maximum/minimum            01/01/70 00:00      
                     Agree            01/01/70 00:00      
               3V3 logic runs at "TTL levels"            01/01/70 00:00      
                  The HD44780 claims to respond to TTL levels ... but ...            01/01/70 00:00      
   pull up resistor            01/01/70 00:00      
      do not tie a pin to gnd            01/01/70 00:00      
      many pull-ups            01/01/70 00:00      
         Do you mean...?            01/01/70 00:00      
      one more thing ...            01/01/70 00:00      
   high impedence            01/01/70 00:00      
   lcd EN signal            01/01/70 00:00      
      It is a pre-clear            01/01/70 00:00      
         Thank You            01/01/70 00:00      

Back to Subject List