Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
02/14/12 19:46
Read: times


 		 #185958 - UART bootloader
Responding to: ???'s previous message
Yes, it appears, that writing an UART-based bootloader for the 'LP5x would be possible. But my point was, that none such is pre-programmed by the manufacturer, thus you need some "primary" programmer to program the bootloader anyway.

JW

List of 42 messages in thread
TopicAuthorDate
89LP52            01/01/70 00:00      
   Drop In Replacement??            01/01/70 00:00      
   Always give full part numbers!            01/01/70 00:00      
      STK500, AVRStudio et al.            01/01/70 00:00      
         Officially recommended            01/01/70 00:00      
      AT89LP Developer Studio            01/01/70 00:00      
         LP ISP Studio            01/01/70 00:00      
   Reset?            01/01/70 00:00      
      hitting the nail on the head?            01/01/70 00:00      
         'LP5x accepts both polarities of reset            01/01/70 00:00      
            How?            01/01/70 00:00      
               Care to read the fine manual, Per? :-)            01/01/70 00:00      
                  don't know about Per, I would not ....            01/01/70 00:00      
                  Information can sometimes be hidden            01/01/70 00:00      
               Here is How!!            01/01/70 00:00      
   Program            01/01/70 00:00      
      UART-ISP? I doubt it.            01/01/70 00:00      
         Uart-SPI            01/01/70 00:00      
            UART bootloader            01/01/70 00:00      
               UART bootloader            01/01/70 00:00      
               already inside            01/01/70 00:00      
                  IAP don't mean boot loader exists            01/01/70 00:00      
                     IAP for flash            01/01/70 00:00      
                  two mistakes            01/01/70 00:00      
                     ISP sometimes supported with zero boot loader            01/01/70 00:00      
               Atmel..            01/01/70 00:00      
   89LP52            01/01/70 00:00      
      Thanks for the reply!            01/01/70 00:00      
      OH, NO            01/01/70 00:00      
         FLIP is Atmel's PC-side utility for UART bootloaders            01/01/70 00:00      
            FLIP            01/01/70 00:00      
   STK500 RS232 link commands            01/01/70 00:00      
      yet another choice..            01/01/70 00:00      
      AT89LP52            01/01/70 00:00      
      AT89LP52            01/01/70 00:00      
         Programmers for AT89S and AT89LP            01/01/70 00:00      
            AT89LP52            01/01/70 00:00      
               AT89ISP            01/01/70 00:00      
                  I'd be wary            01/01/70 00:00      
                     way            01/01/70 00:00      
            The very very low cost solution            01/01/70 00:00      
         AT89LP52 options            01/01/70 00:00      

Back to Subject List