Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
07/27/09 13:12
Read: times


 		 #167927 - Not SD - the linked memory
Responding to: ???'s previous message
Richard: Is 8 pins a "lot of pins"?

Note that I did write (emphasis added): "But the big problem is that the price is sky-high even at 500-quantity, and that it is a parallel chip, requiring a very large number of processor pins."

I was not discussing the SD interface, but the chip in this link:
http://search.digikey.com/scripts/D...-1413-1-ND
Unless I goofed up, it has 17 signal lines to reach 2GB/16Gbit which is significantly more than needed for a SD memory.

List of 28 messages in thread
TopicAuthorDate
Embedded SD Memory - anyone seen any?            01/01/70 00:00      
   what's the point?            01/01/70 00:00      
      A microcontroller != flash memory controller            01/01/70 00:00      
         of course not, it's just one task of many ;-)            01/01/70 00:00      
            You actually gain a lot            01/01/70 00:00      
               whatever            01/01/70 00:00      
                  even more to the roots            01/01/70 00:00      
                     Solderability not a problem            01/01/70 00:00      
            There are advantages            01/01/70 00:00      
      Memories can be purchased separately.            01/01/70 00:00      
         memories... of the shelf...            01/01/70 00:00      
            Pricey and consumes a lot of processor pins            01/01/70 00:00      
               an interesting overview            01/01/70 00:00      
               Is 8 pins a "lot of pins"?            01/01/70 00:00      
                  Not SD - the linked memory            01/01/70 00:00      
                     is 17 a very large number? ;-)            01/01/70 00:00      
                        Show me your solderable SD module            01/01/70 00:00      
                           there's nothing to prevent you from soldering a micro-SD            01/01/70 00:00      
                              That's stretching it a bit            01/01/70 00:00      
                        Every extra pin needed can be very expensive            01/01/70 00:00      
   There's cheap SD with PCI            01/01/70 00:00      
      Oddly enough ...            01/01/70 00:00      
         connector issue            01/01/70 00:00      
         The only "issue" is their connector            01/01/70 00:00      
            as opposed to MMC, which uses the same connector            01/01/70 00:00      
   Found it - "iNand"!            01/01/70 00:00      
      how does its cost compare            01/01/70 00:00      
         Dunno            01/01/70 00:00      

Back to Subject List