Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
11/30/12 21:43
Read: times


 		 #188929 - C8051F231 experiences
Dear members,
I have been working succesully with the Silabs part in a 900 MHz RF modem.
But I found some curiosity that could be useful for others. The fact is that, with the board working, I was touching (with bare fingers) some parts (Xtal, MCU, etc), just checking temperature, ability for eventual recovery from oscillator stop, etc. When touching pin 6 (XTAL1, input, high impedance) the clock stops. But, sometimes, with everything connected to ground (even my body), the program stops and it does not start even after recycling power! It is necessary to reprogram the part. It seems that the flash got corrupted by some high voltage spike and/or 50Hz hum.
Solution: cover the Xtal and pin6 area with plastic weldind rod.
I have never seen something like this with other MCUs.

Best regards

Daniel

List of 33 messages in thread
TopicAuthorDate
C8051F231 experiences            01/01/70 00:00      
   another solution            01/01/70 00:00      
   The probabilities are low...            01/01/70 00:00      
      think about what happens when you add a finger            01/01/70 00:00      
         The point is ...            01/01/70 00:00      
            Yes ... the underlying issue is the flash ...             01/01/70 00:00      
               Out of my office, but...            01/01/70 00:00      
                  Don't think in Vcc, ESD or hum...            01/01/70 00:00      
   Apparently several C8051F2xx parts have the same pinout            01/01/70 00:00      
   Characteristic for in system programmable flash micros...            01/01/70 00:00      
      All too true ... sadly ...             01/01/70 00:00      
         Power-on slope rate...            01/01/70 00:00      
            Sorry, my post should be here, no up there...            01/01/70 00:00      
            Have you any basis for that rate?            01/01/70 00:00      
               Vdd ramp time            01/01/70 00:00      
               Some datasheets show numbers...            01/01/70 00:00      
                  Those aren't the "usual" 805x-core MCU's            01/01/70 00:00      
                     There aren't many "usual" 8051-cores anymore...            01/01/70 00:00      
                        How dangerous power ups can be...            01/01/70 00:00      
                           I believe it            01/01/70 00:00      
                              (dV/dt) examples            01/01/70 00:00      
                                 They don't know it either...            01/01/70 00:00      
                                    dV/dT etc             01/01/70 00:00      
                                       reset request...            01/01/70 00:00      
                                          That's what disturbs me greatly            01/01/70 00:00      
                                             It IS disturbing!            01/01/70 00:00      
                                                Where this began ... at least for me ...             01/01/70 00:00      
                                                   So, you took the hard road...            01/01/70 00:00      
                                                      We've all had that experience             01/01/70 00:00      
   probable cause            01/01/70 00:00      
      Brent, this is very nice            01/01/70 00:00      
         forum no longer down            01/01/70 00:00      
      Thank you!            01/01/70 00:00      

Back to Subject List