Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
02/24/06 11:38
Read: times


 		 #110662 - Again
Responding to: ???'s previous message
Suresh R said:
i connected the 555 in monostable state (previously discussed)

If you're going to refer to previous threads, provide a link!

when the trigger is continuously pressed without releasing it, the LED keeps on glowing, but not switching OFF after 1 Sec.

I can't remember off-hand, so I would go and look it up in the Datasheet
You have the datasheet (from your previous thread) - so go and look it up!

i didnt use any debounce circuit or debounce IC in the trigger i/p.

With delays on the order of seconds controlled by a 555 timer, contact bounce is unlikely to be of any significance!

List of 39 messages in thread
TopicAuthorDate
Pressing 555 trigger SW continuously.            01/01/70 00:00      
   Again            01/01/70 00:00      
   capacitor couple it.            01/01/70 00:00      
      Re: cap coupling            01/01/70 00:00      
         Look up the internal block diagram            01/01/70 00:00      
            Read the Data Sheet!!            01/01/70 00:00      
      got the o/p            01/01/70 00:00      
         Satisfaction            01/01/70 00:00      
            Thanku steve            01/01/70 00:00      
         Not enough            01/01/70 00:00      
            alternatives ?            01/01/70 00:00      
               Remedy            01/01/70 00:00      
                  remedy?            01/01/70 00:00      
                     Alternatives            01/01/70 00:00      
                  BC550 & diodes            01/01/70 00:00      
                     Try it by yourself, it's simple!            01/01/70 00:00      
                        analysis results            01/01/70 00:00      
                           Analysis            01/01/70 00:00      
                              Thank you            01/01/70 00:00      
                              after the set delay Time            01/01/70 00:00      
                                 Enhanced debouncing            01/01/70 00:00      
                                    What do you think about it, Suresh?            01/01/70 00:00      
   why the neqw thread            01/01/70 00:00      
      reply            01/01/70 00:00      
         Read the Data Sheet!!            01/01/70 00:00      
   kalpak dabir            01/01/70 00:00      
   Have you considered using a 74121?            01/01/70 00:00      
      74121 versus CMOS555            01/01/70 00:00      
      74121 fine for short period delays?            01/01/70 00:00      
         No debounce needed???            01/01/70 00:00      
            Schmitt trigger operation?            01/01/70 00:00      
               Transition times of input signal            01/01/70 00:00      
                  controlling noise related issues            01/01/70 00:00      
                     Schmitt-trigger operation            01/01/70 00:00      
                      CD 4541BC = Alternative for ICM 7555?            01/01/70 00:00      
                        Do you really need to build it?            01/01/70 00:00      
                           Yes.            01/01/70 00:00      
                              try try try again            01/01/70 00:00      
                                 a sign of confidence            01/01/70 00:00      

Back to Subject List