| ??? 07/25/09 13:22 Read: times |
#167881 - What you propose isn't well suited for 4 layer boards Responding to: ???'s previous message |
Rob said:
For a ground plane to work effectively, it must be as uninterrupted as possible and there is just no way to achieve that on the component layer of an SMT board. Joseph said:
Please elaborate. How do you figure this? What Rob wants to mention is very simple: If you have on the top layer many SMD parts with their many solder pads, how can you then have a solid ground plane on this layer at the same time? Also, with 4 layer boards there's another reason why you should not have the two signal layers inside, just because then you have no shielding plane between them! Routing signals on inner layers can be done, when using a (>)6 layer board, though. Then you have two component layers with ground fills outside, two inner signal layers, a solid ground plane and solid Vcc plane which can act as shielding planes. Kai |
| Topic | Author | Date |
| PCB design - ground plate... | 01/01/70 00:00 | |
| excuse... | 01/01/70 00:00 | |
| You can use a local ground plane, but... | 01/01/70 00:00 | |
| So, if I understand it well... | 01/01/70 00:00 | |
| Yes, of course, but... | 01/01/70 00:00 | |
| Yes, but... | 01/01/70 00:00 | |
| No overlap | 01/01/70 00:00 | |
| Version B, but without FB... | 01/01/70 00:00 | |
| so... | 01/01/70 00:00 | |
| PCB layout... | 01/01/70 00:00 | |
| Answers... | 01/01/70 00:00 | |
| EMC | 01/01/70 00:00 | |
| Hhm, I wouldn't do that... | 01/01/70 00:00 | |
| AC power supply | 01/01/70 00:00 | |
| ground vias | 01/01/70 00:00 | |
| Locating of vias... | 01/01/70 00:00 | |
| Thank you very much... | 01/01/70 00:00 | |
| Sideplating? Thermal vias? | 01/01/70 00:00 | |
| Stackup | 01/01/70 00:00 | |
| Not such a good idea | 01/01/70 00:00 | |
| interrupted/split planes | 01/01/70 00:00 | |
| Elaboration | 01/01/70 00:00 | |
| Thank you... | 01/01/70 00:00 | |
| Nice link, Rob! | 01/01/70 00:00 | |
| Elaboration | 01/01/70 00:00 | |
| Explanation | 01/01/70 00:00 | |
| Elaboration | 01/01/70 00:00 | |
| What you propose isn't well suited for 4 layer boards | 01/01/70 00:00 | |
Hi Kai | 01/01/70 00:00 |