??? 12/20/05 11:29 Read: times |
#105581 - Reply : Heating Responding to: ???'s previous message |
Terry Lingle said:
The mid point should not be connected to the ground as it will short the two diodes that connect to the - output of the bridge across the transformer winding . This was the mistake i have done. Thanks very much Terry. I would like to get suggestions for the following if possible. It is the same board i described earlier. The o/p of 7805 reads 5VDC But the LED connected to its o/p through a 500 ohms resistor glows dim. It would be fine if i could get to know about the various reasons for such low power o/p (refering my design). Note: The transformer is rated at 12V/3A. The negative o/p of the bridge rectifier is left unconnected since iam not using any neg supply. The Schematic can be obtained using the link below http://www.8052.com/users/Suresh/Schematic.pdf Thanking you, -suresh. |
Topic | Author | Date |
Add on card programming | 01/01/70 00:00 | |
please clarify | 01/01/70 00:00 | |
RE: please clarify | 01/01/70 00:00 | |
(E)ISA addressing | 01/01/70 00:00 | |
IOW and IOR | 01/01/70 00:00 | |
not explicitly | 01/01/70 00:00 | |
IRQ in EISA slot | 01/01/70 00:00 | |
interrupt | 01/01/70 00:00 | |
QBASIC programming | 01/01/70 00:00 | |
reply | 01/01/70 00:00 | |
DIP Switch Address Setting in EISA card | 01/01/70 00:00 | |
DIP switches... | 01/01/70 00:00 | |
card design enclosed | 01/01/70 00:00 | |
comparator | 01/01/70 00:00 | |
QBASIC live and well. | 01/01/70 00:00 | |
NT - not quite | 01/01/70 00:00 | |
timing in Win? | 01/01/70 00:00 | |
QBasic Lives!!! | 01/01/70 00:00 | |
refer to 'Barry B Brey' | 01/01/70 00:00 | |
EISA Bus interfacing | 01/01/70 00:00 | |
beware if (E)ISA bus books | 01/01/70 00:00 | |
Try this? | 01/01/70 00:00 | |
Power resistor selection | 01/01/70 00:00 | |
dont do it | 01/01/70 00:00 | |
LM317 is an option | 01/01/70 00:00 | |
Wasteful! | 01/01/70 00:00 | |
if op can........... | 01/01/70 00:00 | |
Power! | 01/01/70 00:00 | |
basic Ohm's law | 01/01/70 00:00 | |
Trouble shoot | 01/01/70 00:00 | |
heating | 01/01/70 00:00 | |
Reply : Heating | 01/01/70 00:00 | |
if you refer to D4 then | 01/01/70 00:00 |