| ??? 12/13/05 09:10 Read: times |
#105126 - card design enclosed Responding to: ???'s previous message |
Valentin Angelovski said:
can we see it too...? :) Valentin Please use this link to see the card design. http://www.8052.com/users/Suresh/card%20ckt.pdf my doubts are; 1)How the base address of the card is set using the DIP switch arrangement shown in the design. I just want to know the logic behind it. i.e., how the base address could be set, by switching the DIP switch 'ON' or 'OFF' . 2)what is the initial state of the address lines and data lines(high or low) in the ISA slot. your relplies could be very helpful to me regard's -suresh |
| Topic | Author | Date |
| Add on card programming | 01/01/70 00:00 | |
| please clarify | 01/01/70 00:00 | |
| RE: please clarify | 01/01/70 00:00 | |
| (E)ISA addressing | 01/01/70 00:00 | |
| IOW and IOR | 01/01/70 00:00 | |
| not explicitly | 01/01/70 00:00 | |
| IRQ in EISA slot | 01/01/70 00:00 | |
| interrupt | 01/01/70 00:00 | |
| QBASIC programming | 01/01/70 00:00 | |
| reply | 01/01/70 00:00 | |
| DIP Switch Address Setting in EISA card | 01/01/70 00:00 | |
| DIP switches... | 01/01/70 00:00 | |
| card design enclosed | 01/01/70 00:00 | |
| comparator | 01/01/70 00:00 | |
| QBASIC live and well. | 01/01/70 00:00 | |
| NT - not quite | 01/01/70 00:00 | |
| timing in Win? | 01/01/70 00:00 | |
| QBasic Lives!!! | 01/01/70 00:00 | |
| refer to 'Barry B Brey' | 01/01/70 00:00 | |
| EISA Bus interfacing | 01/01/70 00:00 | |
| beware if (E)ISA bus books | 01/01/70 00:00 | |
| Try this? | 01/01/70 00:00 | |
| Power resistor selection | 01/01/70 00:00 | |
| dont do it | 01/01/70 00:00 | |
| LM317 is an option | 01/01/70 00:00 | |
| Wasteful! | 01/01/70 00:00 | |
| if op can........... | 01/01/70 00:00 | |
| Power! | 01/01/70 00:00 | |
| basic Ohm's law | 01/01/70 00:00 | |
| Trouble shoot | 01/01/70 00:00 | |
| heating | 01/01/70 00:00 | |
| Reply : Heating | 01/01/70 00:00 | |
if you refer to D4 then | 01/01/70 00:00 |