Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
04/30/09 04:12
Read: times


 		 #164954 - Re:some basic questions
Responding to: ???'s previous message
How far apart are the local and remote LCD's?

Board C (remote display) is at least 20m away from board A. It's difficult to access where we mount board A to see what shown on the LCD (e.g. board A may be high above ground).

How, exactly, did you intend to interface to the remote board?

I use the same micro controller of board A on board B & C and board C will have the same LCD and its hardware configuration as board A

What, other than the LCD, exactly, will be on the remote board?

Probably nothing else

List of 24 messages in thread
TopicAuthorDate
How to read and redisplay from LCD databus?            01/01/70 00:00      
   Spy on the Data & Control lines            01/01/70 00:00      
      Can be hard to be fast enough            01/01/70 00:00      
   Shouldn't be a problem            01/01/70 00:00      
      some HW might be needed            01/01/70 00:00      
         Monitor the LCD databus then send via 485            01/01/70 00:00      
         I don't see a place for the 805x            01/01/70 00:00      
      Re: Shouldn't be a problem            01/01/70 00:00      
         some basic questions            01/01/70 00:00      
            Re:some basic questions            01/01/70 00:00      
               20 Meters            01/01/70 00:00      
                  Re: 20 Meters            01/01/70 00:00      
      Signal timing and command timing separate issues            01/01/70 00:00      
         Check the datasheet ...            01/01/70 00:00      
            Re: Check the datasheet ... and test on LCD of board B first            01/01/70 00:00      
               A CPLD at each end would do nicely            01/01/70 00:00      
                  Re: A CPLD at each end would do nicely            01/01/70 00:00      
                     it depends on requirements            01/01/70 00:00      
                        Watch out for assumptions about busy            01/01/70 00:00      
                           If that gets to be an issue ...            01/01/70 00:00      
                              slave timing            01/01/70 00:00      
                                 I doubt that will work.            01/01/70 00:00      
   I had done something like this in past            01/01/70 00:00      
      Re: I had done something like this in past            01/01/70 00:00      

Back to Subject List