Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
04/30/09 03:30
Read: times


 		 #164950 - some basic questions
Responding to: ???'s previous message
How far apart are the local and remote LCD's?

How, exactly, did you intend to interface to the remote board?

What, other than the LCD, exactly, will be on the remote board?

RE




List of 24 messages in thread
TopicAuthorDate
How to read and redisplay from LCD databus?            01/01/70 00:00      
   Spy on the Data & Control lines            01/01/70 00:00      
      Can be hard to be fast enough            01/01/70 00:00      
   Shouldn't be a problem            01/01/70 00:00      
      some HW might be needed            01/01/70 00:00      
         Monitor the LCD databus then send via 485            01/01/70 00:00      
         I don't see a place for the 805x            01/01/70 00:00      
      Re: Shouldn't be a problem            01/01/70 00:00      
         some basic questions            01/01/70 00:00      
            Re:some basic questions            01/01/70 00:00      
               20 Meters            01/01/70 00:00      
                  Re: 20 Meters            01/01/70 00:00      
      Signal timing and command timing separate issues            01/01/70 00:00      
         Check the datasheet ...            01/01/70 00:00      
            Re: Check the datasheet ... and test on LCD of board B first            01/01/70 00:00      
               A CPLD at each end would do nicely            01/01/70 00:00      
                  Re: A CPLD at each end would do nicely            01/01/70 00:00      
                     it depends on requirements            01/01/70 00:00      
                        Watch out for assumptions about busy            01/01/70 00:00      
                           If that gets to be an issue ...            01/01/70 00:00      
                              slave timing            01/01/70 00:00      
                                 I doubt that will work.            01/01/70 00:00      
   I had done something like this in past            01/01/70 00:00      
      Re: I had done something like this in past            01/01/70 00:00      

Back to Subject List