Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
04/04/12 06:51
Read: times


 		 #186999 - Layout attached
Responding to: ???'s previous message
USB lines are hardly 1.5 cms long. Almost parallel, but not perfectly parallel. All recommended capacitors for noisy environment is mounted. It is a single side board.

Decoupling cap is 1 cm from chip. But even if you mount them on chip, doesn't help.



List of 36 messages in thread
TopicAuthorDate
FTDI F232RL Noise issues            01/01/70 00:00      
   GND,cables            01/01/70 00:00      
      of this is it, then            01/01/70 00:00      
   leakage effects..            01/01/70 00:00      
      Thanks for the comments..            01/01/70 00:00      
         changing the serial port data....            01/01/70 00:00      
         cable, bought off the shelf            01/01/70 00:00      
            Test standard solutions            01/01/70 00:00      
               Options..            01/01/70 00:00      
                  VCP /D2X            01/01/70 00:00      
                     Problem exists with both drivers            01/01/70 00:00      
                  Aten serial to USB cable uses a FTDI chip            01/01/70 00:00      
   FTDI chip ESD sensitivity            01/01/70 00:00      
      Thanks Oliver...            01/01/70 00:00      
         Zeners are slow            01/01/70 00:00      
         show Your circuit            01/01/70 00:00      
            F232 is USB powered but.. + circuit            01/01/70 00:00      
         USB Isolator Chips            01/01/70 00:00      
            Isolators            01/01/70 00:00      
         Better than zeners            01/01/70 00:00      
            just a thought            01/01/70 00:00      
               Layout            01/01/70 00:00      
                  VCP/Direct drivers            01/01/70 00:00      
                  Layout attached            01/01/70 00:00      
                     It's a high speed circuit !!!!            01/01/70 00:00      
                        Totally 100% Agreed            01/01/70 00:00      
                           the trouble with schematics ....            01/01/70 00:00      
                              Bandwidth limitation            01/01/70 00:00      
   22 ohms between serial port ground and FT232 ground helps...            01/01/70 00:00      
      of course it does            01/01/70 00:00      
         Erik,            01/01/70 00:00      
            Links please            01/01/70 00:00      
               Link...            01/01/70 00:00      
                  Solved            01/01/70 00:00      
                     Magnetics            01/01/70 00:00      
                        Ethernet input is connected to serial port ground            01/01/70 00:00      

Back to Subject List