| ??? 02/16/06 13:53 Read: times |
#110142 - output characteristics Responding to: ???'s previous message |
Basically, 2a and 3 and 4 are points taken from the output characteristics of the port1-2-3 pins.
However, you should remove all the equation signs - please note that the datasheet states min. and max. values (sometimes also typ. but that is usually of little use). So, these points are taken from the two margins of the output characteristics. JW |
| Topic | Author | Date |
| AT89s52 Port pin clarifications: | 01/01/70 00:00 | |
| nice copy, where is the question | 01/01/70 00:00 | |
| output characteristics | 01/01/70 00:00 | |
| most confusing post | 01/01/70 00:00 | |
| Answers | 01/01/70 00:00 | |
| Logic 1 to 0 transition | 01/01/70 00:00 | |
| You haven't read the 'bible' chapter... | 01/01/70 00:00 | |
| no details about transition from logic 1 | 01/01/70 00:00 | |
| other way 'round | 01/01/70 00:00 | |
| There ARE!! | 01/01/70 00:00 | |
| pFET2 | 01/01/70 00:00 | |
| Weak and very weak pull-ups | 01/01/70 00:00 | |
| maintaining low source impedence? | 01/01/70 00:00 | |
| by making thje driver a sink............ | 01/01/70 00:00 | |
| Pull-downs create problems | 01/01/70 00:00 | |
| Maximum IOL per port pin: 10 mA ? | 01/01/70 00:00 | |
| IOL | 01/01/70 00:00 | |
| IOL = 10mA or 1.6mA? in port 1 | 01/01/70 00:00 | |
Depends on load | 01/01/70 00:00 |