| ??? 09/13/10 13:02 Read: times Msg Score: +1 +1 Good Answer/Helpful |
#178548 - Relays Take Drivers Too Responding to: ???'s previous message |
Typical relays also require driver circuits to buffer their coils from the MCU pins. (Of course there are specialty relays with very sensitive coils that may be able to be connected to an MCU port pin directly and operate correctly from 5 volts/3.3 volts at a couple of milliamperes. However it is not clear if this is the type of relay that you had in mind.
Michael Karas |
| Topic | Author | Date |
| I/O pin extension | 01/01/70 00:00 | |
| Start by specify your need | 01/01/70 00:00 | |
| you really have to list down the full requirements | 01/01/70 00:00 | |
| A suggestion | 01/01/70 00:00 | |
| Specefic Requirements | 01/01/70 00:00 | |
| Why relays? | 01/01/70 00:00 | |
| But dot matrix printers normally don't have X*Y array head | 01/01/70 00:00 | |
| Only need *one* column of dots! [ED] | 01/01/70 00:00 | |
| Head has constant speed w/o steps even with stepper motors | 01/01/70 00:00 | |
| reply | 01/01/70 00:00 | |
| not helpful! | 01/01/70 00:00 | |
| Necessity of relays | 01/01/70 00:00 | |
| Relays are not necessary | 01/01/70 00:00 | |
| What's a "design"? | 01/01/70 00:00 | |
| Discrete or integrated | 01/01/70 00:00 | |
| So what's the reason for a slow ctar-at-a-time head? | 01/01/70 00:00 | |
| Printer Purpose | 01/01/70 00:00 | |
| Still no specific reason for a matrix! [Ed] | 01/01/70 00:00 | |
| More care while finding solution | 01/01/70 00:00 | |
| RE: "many others" | 01/01/70 00:00 | |
| Smaller than a relay | 01/01/70 00:00 | |
Relays Take Drivers Too | 01/01/70 00:00 |