| ??? 10/09/13 14:17 Read: times |
#190045 - Re-Poking Pins Responding to: ???'s previous message |
Good Idea ! ! !
I just purchased a bundle of 1x8 cables on eBay and then also purchased some 2x8 connector ends on eBay. These seem to be commonly referred to as "Dupont" wires/cables that are aimed at the Arduino marketplace. I'll remove all wires from one end of a pair of the 1x8's and re-insert them as appropriate into the 2x8 connector. Nice solution, very low cost and ultimately superior to the direct soldered approach on the LCD module. Michael Karas |
| Topic | Author | Date |
| LCD Adapter Assembly / Cable | 01/01/70 00:00 | |
| headers and plugs | 01/01/70 00:00 | |
| Grunch On Ribbon Connectors | 01/01/70 00:00 | |
| Solution | 01/01/70 00:00 | |
| Point Taken | 01/01/70 00:00 | |
| two solutions | 01/01/70 00:00 | |
| Almost | 01/01/70 00:00 | |
| pin layout | 01/01/70 00:00 | |
| Re-Poking Pins | 01/01/70 00:00 | |
| I've seen this, but is it "standard"? | 01/01/70 00:00 | |
| Standard??? | 01/01/70 00:00 | |
| Doubtful if there is any standard what so ever. | 01/01/70 00:00 | |
Standard is probably a poor choice of terms ...  | 01/01/70 00:00 |