Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
10/15/10 04:49
Read: times


 		 #179117 - Not an opamp
Responding to: ???'s previous message
That would be a possibility, and another error source.
I assume you are using a resistor divider. switch different divider resistors.
The fluke meter(which you did not specify which one) uses whatever it uses. The accuracy is listed in its manual. A is only within that if it is calibrated.

List of 24 messages in thread
TopicAuthorDate
Measure temperature @0.1deg resolution using thermistor            01/01/70 00:00      
   Sorry - doesn't work            01/01/70 00:00      
      Thermistors aren't such bad...            01/01/70 00:00      
         Remember the original requirement of 0.1°C            01/01/70 00:00      
   Resolution is not there...            01/01/70 00:00      
      What about the Termistor            01/01/70 00:00      
      RE: Resolution is not there...            01/01/70 00:00      
         one-wire sensors are still quite expensive than thermistors            01/01/70 00:00      
            Thermistor Vs one-wire sensor cost            01/01/70 00:00      
               Your processor has a voltage reference good enough?            01/01/70 00:00      
                  Voltage reference            01/01/70 00:00      
                     That voltage reference has large error...            01/01/70 00:00      
                  Vref is Not Needed            01/01/70 00:00      
                     Depends            01/01/70 00:00      
                        Ah but,            01/01/70 00:00      
                           Still not trivial            01/01/70 00:00      
         The normal fluke doesn't give 0.1C correct readings            01/01/70 00:00      
         I think your customer ...            01/01/70 00:00      
            quite common problem with resolution/precision            01/01/70 00:00      
         linearing only solves one issue            01/01/70 00:00      
            Precision            01/01/70 00:00      
               hm            01/01/70 00:00      
               Not an opamp            01/01/70 00:00      
               Comparison with Fluke a big problem            01/01/70 00:00      

Back to Subject List