Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
10/12/10 07:28
Read: times


 		 #179061 - Thermistor Vs one-wire sensor cost
Responding to: ???'s previous message
Andy Neil said:

Therefore, for a valid price comparison, you need to consider the cost of the thermistor plus its signal conditioning plus an ADC...


Andy, my MCU has inbuilt ADC so no extra cost for ADC.

If I bias thermistor from a 3V or 2.5V reference through a single resistor, I can connect the voltage across thermistor directly to the ADC input pins. Or do I need signal conditioning?


List of 24 messages in thread
TopicAuthorDate
Measure temperature @0.1deg resolution using thermistor            01/01/70 00:00      
   Sorry - doesn't work            01/01/70 00:00      
      Thermistors aren't such bad...            01/01/70 00:00      
         Remember the original requirement of 0.1°C            01/01/70 00:00      
   Resolution is not there...            01/01/70 00:00      
      What about the Termistor            01/01/70 00:00      
      RE: Resolution is not there...            01/01/70 00:00      
         one-wire sensors are still quite expensive than thermistors            01/01/70 00:00      
            Thermistor Vs one-wire sensor cost            01/01/70 00:00      
               Your processor has a voltage reference good enough?            01/01/70 00:00      
                  Voltage reference            01/01/70 00:00      
                     That voltage reference has large error...            01/01/70 00:00      
                  Vref is Not Needed            01/01/70 00:00      
                     Depends            01/01/70 00:00      
                        Ah but,            01/01/70 00:00      
                           Still not trivial            01/01/70 00:00      
         The normal fluke doesn't give 0.1C correct readings            01/01/70 00:00      
         I think your customer ...            01/01/70 00:00      
            quite common problem with resolution/precision            01/01/70 00:00      
         linearing only solves one issue            01/01/70 00:00      
            Precision            01/01/70 00:00      
               hm            01/01/70 00:00      
               Not an opamp            01/01/70 00:00      
               Comparison with Fluke a big problem            01/01/70 00:00      

Back to Subject List