Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
11/23/09 15:20
Read: times


 		 #171069 - You are totally right, of course...
Responding to: ???'s previous message
Andy said:
Is it a good way to welcome a newbie to 8052.com - by making jokes at his expense?


Yes, you are totally right, but I couldn't resist...

Look, what the OP wrote:

Syed said:
i want to make scrolling message board using 8051 assembly language...
using 4 8x8 dot matrix display...


This is so much lacking in information, see the dots, and so full of lazyness! Oh sorry, I forgot, he needs additional efforts to also type these lines into other fora.

I hope, Syed will understand what I meant and will come back to give further details on what he intends to do, and, of course, to tell us what he has done so far. We cannot do all his job. Helping is ok, but he didn't tell us where he needs help, or did he...?

Kai Klaas


List of 27 messages in thread
TopicAuthorDate
help me            01/01/70 00:00      
   first you must design            01/01/70 00:00      
      Or register and buy design and report            01/01/70 00:00      
   Ok...            01/01/70 00:00      
      Very amusing, but            01/01/70 00:00      
         You are totally right, of course...            01/01/70 00:00      
      you forgot to tie a pair of reading glasses to the lifebelt            01/01/70 00:00      
         A Thought            01/01/70 00:00      
            Allthough I hate generalisations...            01/01/70 00:00      
               That's where the scores could really help            01/01/70 00:00      
                  Same IP?            01/01/70 00:00      
               I'd say 12 hours or so ...            01/01/70 00:00      
   Does this look familiar to anyone?            01/01/70 00:00      
   the old nugget            01/01/70 00:00      
      I do no longer think, that it's always HW...            01/01/70 00:00      
         and ...            01/01/70 00:00      
            SO! ... that explains it ... you're an Ingeneer ...            01/01/70 00:00      
         another possibility            01/01/70 00:00      
            resolution.. precision.. accuracy.. demystifying the myth            01/01/70 00:00      
               I think you have 'em reversed.            01/01/70 00:00      
                  Some dictionaries claim the two are synonymous.            01/01/70 00:00      
                  No that is the correct definition            01/01/70 00:00      
                     Cartoon            01/01/70 00:00      
                  ASTM            01/01/70 00:00      
            Yes, that is a common misconception.            01/01/70 00:00      
            Many ways to fail            01/01/70 00:00      
   Well....            01/01/70 00:00      

Back to Subject List