| ??? 01/18/13 00:50 Read: times |
#189245 - 'BQL' version could be an option Responding to: ???'s previous message |
Jim Granville said:
The ATF16V8BQL has a typical measured Static Icc of ~1.5mA, so it is not as low as a 'Z' part, (which are uA-static region parts), but for many designs that run something else, 1.5mA is quite ok. It is also a little cheaper than the ATF16V8CZ :) Might be an option to take the 'BQL' version |
| Topic | Author | Date |
| Reset issue with new Atmel AT89LP51ED2 | 01/01/70 00:00 | |
| Do never use a µC from which only a preliminary... | 01/01/70 00:00 | |
| configuration settings | 01/01/70 00:00 | |
| what about negative reset? | 01/01/70 00:00 | |
| good idea but | 01/01/70 00:00 | |
| Some things to check... | 01/01/70 00:00 | |
| also try no LM810 at all | 01/01/70 00:00 | |
| reset is inverted | 01/01/70 00:00 | |
| no strange signals | 01/01/70 00:00 | |
| Extra modes ? | 01/01/70 00:00 | |
| pull-up on PSEN solves the problem | 01/01/70 00:00 | |
| small capacitor ? | 01/01/70 00:00 | |
| small capacitor | 01/01/70 00:00 | |
| side-stepping the problem? | 01/01/70 00:00 | |
| SST could be an option | 01/01/70 00:00 | |
| final status AT89LP51ED2 reset | 01/01/70 00:00 | |
| Clarifies | 01/01/70 00:00 | |
| loads on PSEN | 01/01/70 00:00 | |
| An isolated PSEN works fine ? | 01/01/70 00:00 | |
| GAL causes problem | 01/01/70 00:00 | |
| ATF16V8CZ has Pin-keeper | 01/01/70 00:00 | |
| 'Z' indeed | 01/01/70 00:00 | |
| ATF16V8BQL has Icc of ~1.5mA | 01/01/70 00:00 | |
'BQL' version could be an option | 01/01/70 00:00 |