| ??? 01/16/13 12:59 Read: times |
#189188 - configuration settings Responding to: ???'s previous message |
The board is an existing one with active high reset : POL, EA = tied high
Xtal = 20Mc, and running after (hardware)reset Rise time goes from 10�µs to 5ms, but it fails in either situations. It feels like if the Vcc is not fully 0V, it work (reset) a bit better. But it should work in any case as you can not predict the situation in a practical situation I mailed the configuration settings ( ASIX Presto programmer ) to Atmel and it was ok. Koen |
| Topic | Author | Date |
| Reset issue with new Atmel AT89LP51ED2 | 01/01/70 00:00 | |
| Do never use a µC from which only a preliminary... | 01/01/70 00:00 | |
| configuration settings | 01/01/70 00:00 | |
| what about negative reset? | 01/01/70 00:00 | |
| good idea but | 01/01/70 00:00 | |
| Some things to check... | 01/01/70 00:00 | |
| also try no LM810 at all | 01/01/70 00:00 | |
| reset is inverted | 01/01/70 00:00 | |
| no strange signals | 01/01/70 00:00 | |
| Extra modes ? | 01/01/70 00:00 | |
| pull-up on PSEN solves the problem | 01/01/70 00:00 | |
| small capacitor ? | 01/01/70 00:00 | |
| small capacitor | 01/01/70 00:00 | |
| side-stepping the problem? | 01/01/70 00:00 | |
| SST could be an option | 01/01/70 00:00 | |
| final status AT89LP51ED2 reset | 01/01/70 00:00 | |
| Clarifies | 01/01/70 00:00 | |
| loads on PSEN | 01/01/70 00:00 | |
| An isolated PSEN works fine ? | 01/01/70 00:00 | |
| GAL causes problem | 01/01/70 00:00 | |
| ATF16V8CZ has Pin-keeper | 01/01/70 00:00 | |
| 'Z' indeed | 01/01/70 00:00 | |
| ATF16V8BQL has Icc of ~1.5mA | 01/01/70 00:00 | |
'BQL' version could be an option | 01/01/70 00:00 |