| ??? 03/04/09 01:53 Read: times |
#163046 - my mistake Responding to: ???'s previous message |
Yes, as usual you all are correct. From the documentation: "The board can be populated with a 32.768kHz watch crystal or a MHz crystal. This crystal is connected between the XTAL1 and XTAL2 pins. The watch crystal is populated for parts with an on chip PLL, the MHz crystal (11.0592MHz) is used for the other parts."
Looking at my board, it is indeed populated with the 11.0592 MHz XTAL so I believe I have the baud rate is set up correctly in the code. Why would a U come through fine but other characters have trouble? Brian |
| Topic | Author | Date |
| serial comm problem | 01/01/70 00:00 | |
| what about TI? | 01/01/70 00:00 | |
| thank you | 01/01/70 00:00 | |
| Be better... | 01/01/70 00:00 | |
| no luck | 01/01/70 00:00 | |
| Settings | 01/01/70 00:00 | |
| What is your XTAL frequency ? | 01/01/70 00:00 | |
| parity and XTAL | 01/01/70 00:00 | |
| Eh ? | 01/01/70 00:00 | |
| one or the other | 01/01/70 00:00 | |
| my mistake | 01/01/70 00:00 | |
| scope pictures | 01/01/70 00:00 | |
| whatizit? | 01/01/70 00:00 | |
| where I measured it... | 01/01/70 00:00 | |
| waveforms look OK | 01/01/70 00:00 | |
| question | 01/01/70 00:00 | |
| LSBit comes first after startbit | 01/01/70 00:00 | |
| cable | 01/01/70 00:00 | |
| isolation and ESD protection | 01/01/70 00:00 | |
I have blown very few, if any, MAX232's | 01/01/70 00:00 | |
| Your scope trace looks normal | 01/01/70 00:00 | |
| more pics | 01/01/70 00:00 | |
| show picture at PC side | 01/01/70 00:00 |