Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
11/24/12 11:51
Read: times


 		 #188878 - Undefined behaviour!
Responding to: ???'s previous message
Raj Nambiar said:
which components would fail?

If you're operating parts outside their specified limits, then the behaviour is Undefined - so there is no way to tell what will fail, or how.




List of 27 messages in thread
TopicAuthorDate
-40 degree Celsius operation            01/01/70 00:00      
   Heating pads            01/01/70 00:00      
   Undefined behaviour!            01/01/70 00:00      
      bending it in neon            01/01/70 00:00      
         That means that you're on your own ... no support             01/01/70 00:00      
   Why?            01/01/70 00:00      
      Not in Dubai            01/01/70 00:00      
         nobody has been that stupid            01/01/70 00:00      
         So many pitfalls...            01/01/70 00:00      
            testing            01/01/70 00:00      
               And what is the cost of testing?            01/01/70 00:00      
                  the cost of testing            01/01/70 00:00      
                     it's not just pass/fail ...             01/01/70 00:00      
                        Tell me about it!            01/01/70 00:00      
                        Why?            01/01/70 00:00      
                           Why??? It's to protect your own gluteus maximus            01/01/70 00:00      
         what would happen             01/01/70 00:00      
   Heaters/controllers            01/01/70 00:00      
   Low temp components            01/01/70 00:00      
      Potting wont help             01/01/70 00:00      
         it's probably less costly to heat a small enclosure            01/01/70 00:00      
            at very cold start...            01/01/70 00:00      
               Yes it can ...            01/01/70 00:00      
   it's not that simple ...             01/01/70 00:00      
      heater            01/01/70 00:00      
         With an NTC resistor driving the base?            01/01/70 00:00      
            It's very simple...            01/01/70 00:00      

Back to Subject List