Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
01/13/09 08:06
Read: times


 		 #161474 - boost the driver current
Responding to: ???'s previous message
Ap Charles said:


Jeckson, you can boost the driver current if you have more cable capacitance , if you get around 30-45mA it would be ok for 2400pF capacitance , just recalling the 30-45mA figure . You need to study it.

-Ap


How to boost the current?..that's the interface IC chip.

--------------

I'm thinking about the Capasitors for Interface IC's...
How about to increase or decrease the value..between 10uF-0.1uF.([ump Capasitor) Is that made influence the distance without degradate the speed?

Thank's
Jeckson Ben





List of 28 messages in thread
TopicAuthorDate
Someone gave me suggest            01/01/70 00:00      
   Unhelpful subject line            01/01/70 00:00      
   I would use RS485 instead            01/01/70 00:00      
      it would be easier ..            01/01/70 00:00      
      rs-485 with fullduplex            01/01/70 00:00      
         Not 485            01/01/70 00:00      
            rs-485 not the rs-232 signal            01/01/70 00:00      
               Have you actually looked at any datasheets yet?            01/01/70 00:00      
         More details , RTS, DTR            01/01/70 00:00      
            6 lines uart and 2 power supply            01/01/70 00:00      
               RE: Could I used CAT-5            01/01/70 00:00      
               Yes (Little Maths)            01/01/70 00:00      
                  speed??            01/01/70 00:00      
                     You do the maths!            01/01/70 00:00      
                  1200pF ?            01/01/70 00:00      
                     Similiar confused me...            01/01/70 00:00      
                        One more point.            01/01/70 00:00      
                           boost the driver current            01/01/70 00:00      
                              No linear relationship            01/01/70 00:00      
                     Its EIA- 232 D&E standard            01/01/70 00:00      
                        Not relevant here - beyond the spec!            01/01/70 00:00      
                           3 TX and 3 Rx distance 20 m and 115K2            01/01/70 00:00      
                              What does the datasheet tell you?            01/01/70 00:00      
                                 Thank's            01/01/70 00:00      
                                    Try this one aswell            01/01/70 00:00      
                                    before testing            01/01/70 00:00      
                                       What "testing"            01/01/70 00:00      
   RE: The data speed must 115K2            01/01/70 00:00      

Back to Subject List