| ??? 04/21/10 19:55 Read: times |
#175239 - I caught that... Responding to: ???'s previous message |
Rob,
Yes, I did notice that. As I said before, I just tinker in this area so I am no expert but I was able to get the circuit to function as desired, at least in Multisim. I will be building the real deal and will use the function generator and scope to verify its working as intended.... The circuit I put together is below. If you see anything I am obviously overlooking, please let me know. 
The 3 ohm resistor is just in there to simulate the load the circuit will be driving. Thanks again for your advice, Brian. |
| Topic | Author | Date |
| high current output SSR or opto | 01/01/70 00:00 | |
| Something like this perhaps? | 01/01/70 00:00 | |
| thank you | 01/01/70 00:00 | |
| Use due care... | 01/01/70 00:00 | |
| expansion | 01/01/70 00:00 | |
| Depends | 01/01/70 00:00 | |
| I agree | 01/01/70 00:00 | |
| Bleh! | 01/01/70 00:00 | |
| I caught that... | 01/01/70 00:00 | |
| half voltage | 01/01/70 00:00 | |
| why load is there | 01/01/70 00:00 | |
| Check These Items | 01/01/70 00:00 | |
| Load Placement | 01/01/70 00:00 | |
| Load placement | 01/01/70 00:00 | |
| thank you everyone | 01/01/70 00:00 | |
| 3 ohm load | 01/01/70 00:00 | |
| good advice | 01/01/70 00:00 | |
| If I understood your requiremnt properly have a look ULN2003 | 01/01/70 00:00 | |
I don't think so | 01/01/70 00:00 |