Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
07/06/09 14:00
Read: times


 		 #166789 - Open drain pulled up to 5V..
Responding to: ???'s previous message
Erik, open drain pulled up to 5 volts should work. Shouldn't it?

Is there some clever way to drive this PNP by adding a resistor or diode or something?

List of 33 messages in thread
TopicAuthorDate
Driving a 5 v PNP with 3.3 volts pin            01/01/70 00:00      
   Diagram ?            01/01/70 00:00      
      Sketch..            01/01/70 00:00      
         Steve..            01/01/70 00:00      
            Why push-pull?            01/01/70 00:00      
               Thanks Rob            01/01/70 00:00      
               Very much depending on chip            01/01/70 00:00      
                  Yeah, but ...            01/01/70 00:00      
                     Better always add a note for potentially dangerous methods            01/01/70 00:00      
                        Is that my responsability?            01/01/70 00:00      
                  Westermark            01/01/70 00:00      
                     Erik did exmplain            01/01/70 00:00      
                        Sorry Westermark..            01/01/70 00:00      
         KISS            01/01/70 00:00      
   If it has not to be a PNP...            01/01/70 00:00      
      Relay has to be driven..            01/01/70 00:00      
         since I would never do that ...            01/01/70 00:00      
            Open drain pulled up to 5V..            01/01/70 00:00      
               did you read my post            01/01/70 00:00      
                  Deep waters            01/01/70 00:00      
                     OK, more            01/01/70 00:00      
                        I missed this post..            01/01/70 00:00      
      BC556 would turn on, wouldn't it?            01/01/70 00:00      
         It wouldn't. Sorry.            01/01/70 00:00      
   Have you considered a pMOSFET?            01/01/70 00:00      
      Yep, I second that! Use a FET            01/01/70 00:00      
         Have you considered that he must drive a 5V relay?            01/01/70 00:00      
            Does that really matter?            01/01/70 00:00      
               To what do you connect the source of this pMOSFET??            01/01/70 00:00      
                  It's the switched drain current that does the work            01/01/70 00:00      
                     Of course, it does! But...            01/01/70 00:00      
                        One could also use a "switch" ...            01/01/70 00:00      
                           Yes, that's safe!            01/01/70 00:00      

Back to Subject List