| ??? 05/03/08 07:48 Read: times |
#154328 - Never say never.... Responding to: ???'s previous message |
Be careful saying "cannot be used". To confine solutions to crap products or garbage schemes is destined to failure every time. It is often necessary to think outside the box and devise a solution that does not fit the original conception of form factor!!!
In the case of load cells one only has to do a modicum of research to realize that these things are available in a dizzying array of sizes and configurations. Michael Karas |
| Topic | Author | Date |
| Flexiforce sensor and chip | 01/01/70 00:00 | |
| op-amp output is what you will get | 01/01/70 00:00 | |
| Correct | 01/01/70 00:00 | |
| 'typical' job for a '51 | 01/01/70 00:00 | |
| PLC | 01/01/70 00:00 | |
| sounds like a plan | 01/01/70 00:00 | |
| Have you noticed, ... | 01/01/70 00:00 | |
| It is but ... | 01/01/70 00:00 | |
| Stretching the inverting amplifier is crap! | 01/01/70 00:00 | |
| I Agree; This Sensor is... | 01/01/70 00:00 | |
| Dimensional Constraints | 01/01/70 00:00 | |
| Never say never.... | 01/01/70 00:00 | |
| load cell <> strain gauge | 01/01/70 00:00 | |
| Its hard some times | 01/01/70 00:00 | |
| Terminology | 01/01/70 00:00 | |
| Flexiforce | 01/01/70 00:00 | |
| Specification | 01/01/70 00:00 | |
| I think it is great | 01/01/70 00:00 | |
| Ejector seat ? | 01/01/70 00:00 | |
| With what sitting in the seat? | 01/01/70 00:00 | |
| Anything | 01/01/70 00:00 | |
Even moderators? | 01/01/70 00:00 | |
| what else would anyone expect from an FSR | 01/01/70 00:00 | |
| Well. | 01/01/70 00:00 |