| ??? 03/09/10 05:46 Read: times |
#173953 - min & max limits Responding to: ???'s previous message |
Joel Ward said:
may I ask why the timing is supposed to be so crucial, I can understand that an underestimated delay would lead to the display not reading the data correctly, but lengthy delays will surely only mean the code will run slowly. Very often, there are both minimum and maximum timing requirements... |
| Topic | Author | Date |
| Display problems | 01/01/70 00:00 | |
| forgot to mention! | 01/01/70 00:00 | |
| read the datasheet and buy the iron | 01/01/70 00:00 | |
| just a minute ... | 01/01/70 00:00 | |
| If you can't "afford" the one pin for the R/W signal | 01/01/70 00:00 | |
| Why not address his question instead of wasting more money? | 01/01/70 00:00 | |
| odd behaviour | 01/01/70 00:00 | |
| Magic? | 01/01/70 00:00 | |
| oscilloscope is fine, but in this case... | 01/01/70 00:00 | |
| Both, I think | 01/01/70 00:00 | |
| "magic" is synonym for "luck" | 01/01/70 00:00 | |
| working | 01/01/70 00:00 | |
| min & max limits | 01/01/70 00:00 | |
| Delay lengths | 01/01/70 00:00 | |
If only folks would do what we once always did ... | 01/01/70 00:00 | |
| RW pin is defined but | 01/01/70 00:00 |