| ??? 11/26/10 09:17 Read: times |
#179646 - Who is the designer ?? Stand up.... Responding to: ???'s previous message |
Stefan Kanev said:
Hi,
....In my opinion - your Darlington driver is not configured properly - at least base-emitter resistors are missing. Rethink things! regards Hey you guys at National Instruments! are you listening ?? Raghu PS : What was attached is a block schematic in the user manual of the PCI card. It does not purport to be a full circuit diagram with parts list. |
| Topic | Author | Date |
| Switch off a LED array | 01/01/70 00:00 | |
| What are the switches? | 01/01/70 00:00 | |
| Virtual ground at 3.3V | 01/01/70 00:00 | |
| 3.3V Regulator Idea | 01/01/70 00:00 | |
| The 3.3V regulator idea might not work! | 01/01/70 00:00 | |
| It is a SOURCE board ... | 01/01/70 00:00 | |
| Hhm, leakage currents? | 01/01/70 00:00 | |
| Solution in sight | 01/01/70 00:00 | |
| LED tester shows bad design/bad parts | 01/01/70 00:00 | |
| Who is the designer ?? Stand up.... | 01/01/70 00:00 | |
| LED tester shows bad design/bad parts | 01/01/70 00:00 | |
| I wouldn't rely on anything published by NI | 01/01/70 00:00 | |
| crying wolf again?? | 01/01/70 00:00 | |
| NI is not a fly-by-night-operator | 01/01/70 00:00 | |
| No question about that | 01/01/70 00:00 | |
| The "crying wolf" is right here... | 01/01/70 00:00 | |
| I also say it... | 01/01/70 00:00 | |
Leakage current analysis | 01/01/70 00:00 | |
| Also, the voltage across the load.... | 01/01/70 00:00 |