| ??? 03/18/09 23:03 Read: times |
#163620 - the JMP Responding to: ???'s previous message |
Hi again Kai... I know about the delay, I have put because I didnt have anything to scope the output, so the only way was with my eyes.
Who is messing with my application is the JMP Run you have removed. With it there the codes keep P2.0 all time low with PWMVal=0 and P2.0 all time high when PWMVal=255. |
| Topic | Author | Date |
| Simple PWM to drive led | 01/01/70 00:00 | |
| Loop lasts too long! | 01/01/70 00:00 | |
| I put the delay... | 01/01/70 00:00 | |
| Did you see? | 01/01/70 00:00 | |
| didnt noticed! | 01/01/70 00:00 | |
| Ok, try the following... | 01/01/70 00:00 | |
| the JMP | 01/01/70 00:00 | |
| I thought this was your intention... | 01/01/70 00:00 | |
| Another try | 01/01/70 00:00 | |
| is possible to filter the pwm output... | 01/01/70 00:00 | |
| PWM from a Timer interrupt? | 01/01/70 00:00 | |
| questions | 01/01/70 00:00 | |
| best code until now | 01/01/70 00:00 | |
| read replies | 01/01/70 00:00 | |
| will lower refresh rate | 01/01/70 00:00 | |
| Time to switch... | 01/01/70 00:00 | |
| Wrong. | 01/01/70 00:00 | |
| my code is doing what I want | 01/01/70 00:00 | |
| TIming | 01/01/70 00:00 | |
| FOR NOW!!!! | 01/01/70 00:00 | |
| The old story... | 01/01/70 00:00 | |
| DJNZ | 01/01/70 00:00 | |
| Dec | 01/01/70 00:00 | |
| Do nothing? | 01/01/70 00:00 | |
| Speed | 01/01/70 00:00 | |
| slowdown | 01/01/70 00:00 | |
| Chico | 01/01/70 00:00 | |
| Not yet... | 01/01/70 00:00 | |
good catch | 01/01/70 00:00 |