| ??? 03/15/08 17:43 Read: times |
#152281 - I have had some luck! Responding to: ???'s previous message |
The data sheets I have found and downloaded so far just give connection details which are probably enough to allow me to connect to my board safely.
In fact a pdf data sheet I have found on the Powertip device suggests one is a 4004 A series and the data sheet has the same information as in the Hitachi book and only refers to one Enable line. Also it lists a Vee line on pin 16 as a negative voltage generator, details of which I can not find within the data sheet for that device but I assume is there to generate a neg voltage for extended temperature use and therefore greater adjustment of viewing angle! The Vertronics pdf matches one of my displays as a MDL(S)40466 and shows the E1 and E2 pins but again does not give me a clue as to using the two lines hence my initial questions as to could I drive them together, why two lines etc. I will try to hook one of them up soon and play! Cheers Adrian |
| Topic | Author | Date |
| 4 x 40 LCD display | 01/01/70 00:00 | |
| Two E's | 01/01/70 00:00 | |
| Dual Init | 01/01/70 00:00 | |
| Thanks | 01/01/70 00:00 | |
| Have you considered looking for a datasheet? | 01/01/70 00:00 | |
| I have had some luck! | 01/01/70 00:00 | |
| You could, of course, trace the circuit | 01/01/70 00:00 | |
| COB's hard to trace... | 01/01/70 00:00 | |
| 4004A | 01/01/70 00:00 | |
| PC4004-A Controller Data Sheet | 01/01/70 00:00 | |
Thanks downloaded and saved | 01/01/70 00:00 |