Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
10/15/12 15:36
Read: times


 		 #188644 - RE: None of them match the Pin structure
Responding to: ???'s previous message
Akhil Bose said:
I am looking for something which can replace the 574 without changes in the circuit board.

Could you make an "adaptor board" to allow some other chip to fit into the existing site on your existing PCB...?

List of 27 messages in thread
TopicAuthorDate
About AD574A            01/01/70 00:00      
   suitable            01/01/70 00:00      
   price/performance            01/01/70 00:00      
      Expensive or old            01/01/70 00:00      
         if it's not "obsolete" it probably should be            01/01/70 00:00      
            It's not obsolete            01/01/70 00:00      
               I wonder what's keeping it "alive"            01/01/70 00:00      
                  It became an industry standard...            01/01/70 00:00      
                     LM358            01/01/70 00:00      
                        Dated            01/01/70 00:00      
   'Find Similar Parts'            01/01/70 00:00      
      I did not find any matching IC            01/01/70 00:00      
         Be Happy            01/01/70 00:00      
            Ok so,            01/01/70 00:00      
               No, that's not what it means!            01/01/70 00:00      
         RE: None of them match the Pin structure            01/01/70 00:00      
   Maxim?            01/01/70 00:00      
      I might be just a bit concerned about the conversion rate            01/01/70 00:00      
   if it is repair, who cares            01/01/70 00:00      
      There are places where that's a week's pay            01/01/70 00:00      
         sure ...            01/01/70 00:00      
            What was the goal?            01/01/70 00:00      
            just a minute ..            01/01/70 00:00      
   Ok ... so here is what i would do            01/01/70 00:00      
      then why the worry about the pinout ?            01/01/70 00:00      
         Thanks Guys            01/01/70 00:00      
            you probably should back away from the original            01/01/70 00:00      

Back to Subject List