Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
08/03/11 17:09
Modified:
  08/03/11 17:33
Read: times


 		 #183180 - finally it worked
Responding to: ???'s previous message
thanks for your help all of you it worked....
the tip about sending lsb first
1/1200 delay for 1200baud rate
and sending 'U's first helped a lot

b.t.w. till what baud rate can i take it up to i was able to transmit at 1200 and 4800 but couldn't do 9600baud

bit its not over yet, i want to implement reception also so bear with me for some more time

List of 30 messages in thread
TopicAuthorDate
bit banging program touble            01/01/70 00:00      
   why?            01/01/70 00:00      
      i need a second serial port            01/01/70 00:00      
         something like this , without any warranty :            01/01/70 00:00      
         a good start would be ...            01/01/70 00:00      
            only 3 'U's are commingout of 100            01/01/70 00:00      
               Separate the characters and look with scope            01/01/70 00:00      
                  finally it worked            01/01/70 00:00      
                     uart receiver in software            01/01/70 00:00      
   No I/O or No Timing            01/01/70 00:00      
      "No I/O or No Timing"            01/01/70 00:00      
   Someday you will learn...            01/01/70 00:00      
      this isnt the actual code            01/01/70 00:00      
         Well then another lesson to learn...            01/01/70 00:00      
   Assembler Manual will help you            01/01/70 00:00      
      assembler manual?            01/01/70 00:00      
   Data is 8 Bit??            01/01/70 00:00      
   Bit width timing and timer TH0,TL0 Values            01/01/70 00:00      
      checked values for TH0 and TL0            01/01/70 00:00      
         keil baud rate Calculator not for bit bang            01/01/70 00:00      
   LSB first            01/01/70 00:00      
   now reception....            01/01/70 00:00      
      1) din = din >> 1            01/01/70 00:00      
         working at 1200 baud            01/01/70 00:00      
            delayRS()            01/01/70 00:00      
               why do i have to sample stop bit            01/01/70 00:00      
                  Need not, but should            01/01/70 00:00      
                  because            01/01/70 00:00      
                     Much to a real UART            01/01/70 00:00      
                  1.5 bit delay            01/01/70 00:00      

Back to Subject List