| ??? 02/10/11 01:11 Read: times |
#181021 - FLIP for AT89C51RB2 Responding to: ???'s previous message |
Thomas Northway said:
I tried the FLIP software for the 89C but couldn't get it to even recognize the device. FLIP is a very straightforward solution to program the Flash and EEPROM memory of the AT89C51RB2(RC2/RD2/RE2). It has just to control the mcu using the "ISP Hardware Condition" sequence as keep PSEN low, provide a short pulse to RESET, release PSEN and the microcontroller is ready to be programmed by FLIP. Or by manulally provide the "Hardware Condition" if the board is equipped with two push-buttons at the RST and PSEN pins. K.L.Angelis |
| Topic | Author | Date |
| SST controllers and IAP | 01/01/70 00:00 | |
| NXP? | 01/01/70 00:00 | |
| SST controllers and IAP | 01/01/70 00:00 | |
| AT89S52 ? | 01/01/70 00:00 | |
| AT89S52 | 01/01/70 00:00 | |
| FLIP for AT89C51RB2 | 01/01/70 00:00 | |
| nuvoton | 01/01/70 00:00 | |
| Nuvoton | 01/01/70 00:00 | |
| some | 01/01/70 00:00 | |
| Thanks | 01/01/70 00:00 | |
why not use STC uC? | 01/01/70 00:00 |