Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
07/17/08 09:03
Read: times


 		 #156793 - Check pins on cable
Responding to: ???'s previous message
Hello Alan

Check if the RX and TX line need to be crossed or not.

Or compare a cable from a PC to your printer and
the cable from your hardware to the printer, if
the same pins show the data (use the oszilloscope)

Best regards
Juergen

List of 32 messages in thread
TopicAuthorDate
SCON code question - data not seen            01/01/70 00:00      
   do you use a proper level convertor?            01/01/70 00:00      
      new cable            01/01/70 00:00      
   two different lever convertors            01/01/70 00:00      
   Check pins on cable            01/01/70 00:00      
      the cable appears to be correct            01/01/70 00:00      
   is data correct on the scope?            01/01/70 00:00      
      analog -vs- DSO            01/01/70 00:00      
         Triangular??            01/01/70 00:00      
         analog scope            01/01/70 00:00      
            oops - use 0x55            01/01/70 00:00      
   check Flow Control            01/01/70 00:00      
   Basics            01/01/70 00:00      
      Thanks Jon            01/01/70 00:00      
   Program works            01/01/70 00:00      
      feed through that wasn't            01/01/70 00:00      
         Correct spelling            01/01/70 00:00      
            just for the numbers or all characters?            01/01/70 00:00      
               In your case, to all            01/01/70 00:00      
                  fixed and not fixed            01/01/70 00:00      
                     not in that code            01/01/70 00:00      
   read mov data, data instruction            01/01/70 00:00      
      biblical            01/01/70 00:00      
         mov direct, direct instruction            01/01/70 00:00      
            to solve this            01/01/70 00:00      
            We talk of mnemonics            01/01/70 00:00      
               what matters is inside mcu            01/01/70 00:00      
                  The manufacturer defines            01/01/70 00:00      
                     Motorola versus Intel            01/01/70 00:00      
                  amateurs might hve some such, but no ..            01/01/70 00:00      
                     the assembler I use            01/01/70 00:00      
            no, it will not            01/01/70 00:00      

Back to Subject List