| ??? 11/11/08 12:52 Modified: 11/11/08 14:05 Read: times |
#159946 - Thanks a bunch Kai , Eric hope Responding to: ???'s previous message |
Kai Klaas said:
You can, if the steady dc current is well below 1A.
The current rating usually only reflects the heat dissipation. Additionally, at higher currents some magnetic saturation of the ferrite can be observed. As a hint, use only 20% of the rated maximum current. Kai Kai hope this holds for small form factor beads only and not for 6Hole or 5 Hole parts. Ap |
| Topic | Author | Date |
| Ferrite six Hole Question (Kai) | 01/01/70 00:00 | |
| 1635782 | 01/01/70 00:00 | |
| BLM18PG471SN1 | 01/01/70 00:00 | |
| You can, if ... | 01/01/70 00:00 | |
| Thanks a bunch Kai , Eric hope | 01/01/70 00:00 | |
| Worst case data valid for all ferrites | 01/01/70 00:00 | |
| 20% ? | 01/01/70 00:00 | |
| 1A -> 200mA | 01/01/70 00:00 | |
Exactly! Two examples... | 01/01/70 00:00 | |
| a very good search can be performed at | 01/01/70 00:00 | |
| Already done that on RS components and Farnell | 01/01/70 00:00 |