| ??? 08/31/06 12:06 Read: times |
#123429 - guessing Responding to: ???'s previous message |
I want to place jumper I am not able to plase jumper in orcad .
Your post is not very clear. if you mean a wire from a to b that may and may not be installed, just make a component and list it DNI (Do Not Install) on the BOM (Bill Of Materials) to do so, you need to put the "component" (the jumper) in the schematic. If you mean "I need a jumper to make the layout work" you should just add some layers to your board, )oh, well, I can already hear "I do not want to do the right thing because it cost money") then you will have to toggle between the schematic and the layout inserting the component (the jumper) in the schematic, then back to layout. Erik |
| Topic | Author | Date |
| Jumper in orcad | 01/01/70 00:00 | |
| guessing | 01/01/70 00:00 | |
| or you could mean a pair of test points ... | 01/01/70 00:00 | |
| Unrouted net | 01/01/70 00:00 | |
| So you're actually using a wire jumper ... | 01/01/70 00:00 | |
| Single sided board? | 01/01/70 00:00 | |
| This might work, but there are some "gotcha's." | 01/01/70 00:00 | |
Single-sided only. | 01/01/70 00:00 | |
| Jumper - how to | 01/01/70 00:00 |