| ??? 09/11/10 09:49 Read: times Msg Score: +1 +1 Good Answer/Helpful |
#178513 - More possible reasons - NOT a good beginner's page! Responding to: ???'s previous message |
While some people have reported some succes with home-made PCB techniques as shown on the mentioned page, it is by no means guaranteed!
And that page doesn't show anything at all about the etching process!! It is quite likely that following that page will give you a non-working PCB! Really, as a beginner, the OP would be far better - at the very least - to buy a ready-made bare PCB, and assemble the components onto that. But that still leaves a significant risk of a non-working assembly due to inexperience with soldering, component identification, etc, etc. Hence it really, really is a better idea to start with a built & tested unit. |
| Topic | Author | Date |
| help me plzzzzzzzzzzzz | 01/01/70 00:00 | |
| Re: | 01/01/70 00:00 | |
| did you fall asleep after 'pl' ? | 01/01/70 00:00 | |
| How far did you go through that site? | 01/01/70 00:00 | |
| Possible reason... | 01/01/70 00:00 | |
| More possible reasons - NOT a good beginner's page! | 01/01/70 00:00 | |
| Even only the layout is a bad joke... | 01/01/70 00:00 | |
"works" | 01/01/70 00:00 |