Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
02/09/10 15:07
Read: times


 
#172994 - This should work well
Responding to: ???'s previous message
The IC regulators must be LDO types, as the headroom is below the requisite 2.2 volts, but that should work out OK. It might be worth considering the SEPIC switcher in place of the first regulator in order to handle the portion of the time that Vin is below 10 volts. Subsequent careful filtering will handle the switcher's ripple.

RE




List of 30 messages in thread
TopicAuthorDate
voltage regulator design            01/01/70 00:00      
   Implement an "Inverting Buck-Boost"...            01/01/70 00:00      
      ultra low noise            01/01/70 00:00      
         You're right ...            01/01/70 00:00      
   reghardless of the urban legends and ...            01/01/70 00:00      
   You need a rail splitter            01/01/70 00:00      
      no, he does not            01/01/70 00:00      
         When the Engine starts            01/01/70 00:00      
            Engine?            01/01/70 00:00      
               Ummm...            01/01/70 00:00      
         That's not a given ...            01/01/70 00:00      
         I stand by what I said            01/01/70 00:00      
            Which one?            01/01/70 00:00      
               Rail splitter            01/01/70 00:00      
                  It isn't as simple as it looks.            01/01/70 00:00      
                     it is ...            01/01/70 00:00      
                        Did you even read the original spec's?            01/01/70 00:00      
                           reverse engineering            01/01/70 00:00      
                  Let me try ..            01/01/70 00:00      
                     Reply            01/01/70 00:00      
                        Reply            01/01/70 00:00      
                  Like this            01/01/70 00:00      
                     This should work well            01/01/70 00:00      
                     The problem with the TLE2426 is...            01/01/70 00:00      
                        quite true, that's why the op-amp is better            01/01/70 00:00      
                           Link....            01/01/70 00:00      
                              probably still too weak ...            01/01/70 00:00      
                                 ...and instable...            01/01/70 00:00      
                        True, opamp alternative            01/01/70 00:00      
                           There are several            01/01/70 00:00      

Back to Subject List