| ??? 04/20/12 05:18 Modified: 04/20/12 05:35 Read: times |
#187230 - Thanks Responding to: ???'s previous message |
Michael Karas said:
Maunik Choksi said:
I found same problem as you described here in the past.I initialsed the LCD thrice and I get success.
Needing to initialize the LCD controller three times to get it to work is an incredible kludge. The most highly likely reason that it does not work correctly on the first initialization attempt is that that you are not meeting either the interface pulse time requirements or you are not meeting the minimum delay requirements between the initialization commands. Michael Karas Yes Mechael it would be one of the reasons.I gave proper time to initialise the LCD controller first & then gave commands according to described in the datasheet.I used different kinds of LCDs too.but couldn't succed.Then I adopt this method.This is the method,not described in the books but didn't disappoint me in a single LCD among I used too many. The OP has write the code properly for initialisation but he find some problem. What the OP should do here to get success in driving the LCD? Your suggession would be helpful me too. Maunik |
| Topic | Author | Date |
| [project]Calculator 4x4 keypad + 2x16LCD - Result | 01/01/70 00:00 | |
| wrong approach | 01/01/70 00:00 | |
| LCD | 01/01/70 00:00 | |
| Initialise it more than one time | 01/01/70 00:00 | |
| Needing To Do Three Times Is A Kludge | 01/01/70 00:00 | |
| Thanks | 01/01/70 00:00 | |
| Intent Applied; But Verified?? | 01/01/70 00:00 | |
| previous experiences | 01/01/70 00:00 | |
' Will see it again | 01/01/70 00:00 |