| ??? 03/21/09 19:32 Read: times |
#163743 - Ok, then... Responding to: ???'s previous message |
...decrease the baud rate to much less than 250kBaud by setting the corresponding timer reload registers, transmit the reset byte (space), increase the baud rate afterwards again to 250kBaud and transmit your frames.
By other words, transmit the reset signal (space) and the frames by different baud rates. Kai |
| Topic | Author | Date |
| 8051 DMX controller (sender) | 01/01/70 00:00 | |
| Forgot to say... project is using 16mhz crystal | 01/01/70 00:00 | |
| Please enlighten us what you mean by "break" | 01/01/70 00:00 | |
| Seems similar to break on RS232 cable | 01/01/70 00:00 | |
| Ok, then... | 01/01/70 00:00 | |
| I think it is just.... | 01/01/70 00:00 | |
| Switch to another serial port mode,... | 01/01/70 00:00 | |
| If Timer 1 is free, use this one. | 01/01/70 00:00 | |
| More about break | 01/01/70 00:00 | |
| Could be possible... | 01/01/70 00:00 | |
| sending DMX512 | 01/01/70 00:00 | |
| Works for Kathy's / Disable uart | 01/01/70 00:00 | |
| Should work... | 01/01/70 00:00 | |
break | 01/01/70 00:00 |