Hi, again, I believe it works, because I cut the 8-pin of DB25 connection with the 126, and change 126 to 125 and test it with:

http://www.mediafire.com/?qjxbngjt1mn

CUSTOM PINOUT:

STROBE1 -> NOT USED
STROBE2 -> NOT USED
RESET -> PIN 3
MOSI -> PIN 9
SCK -> PIN 2
MISO -> PIN 11

FRECUENCY <= FCLK/6 = (example) = 11.0592MHz/6 = 1.8432MHz

(Note: it works up to FCLK/2, but not always)

(More notes: I´m not sure but db25 is TTL?, if so I use HC126 this connection may require pull up resistors (I could use HCT but I don´t have it and in the weekend electronic houses are closed), however I didn´t place it and it still works(so I conclude that the port was not full loaded so VOH > 3.5V))

Some horrible resolution photos:







Regards
Lee