Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
05/12/06 16:04
Read: times


 		 #116103 - re: you could do.
Responding to: ???'s previous message
Dear Kai,

Thanks for your prompt replies,

If you connect B5 directly to C28 then you will not need R27.


Do you mean no resistor where the Vcc line crosses two gnd planes? Please expalin this a bit more. The capacitor at output of LM2937 in digital section is C26.

Thanks & Regards,
Prahlad Purohit


List of 42 messages in thread
TopicAuthorDate
Battery powered hand hel mixed signal            01/01/70 00:00      
   Be prepared to make a mistake            01/01/70 00:00      
      Re: Prepared to make a mistake            01/01/70 00:00      
         We're all learning            01/01/70 00:00      
   Some points...            01/01/70 00:00      
      Re: Some Points.            01/01/70 00:00      
         Answers            01/01/70 00:00      
            Re: Answers.            01/01/70 00:00      
               then...            01/01/70 00:00      
                  How much error can it cause.            01/01/70 00:00      
                     Negligible            01/01/70 00:00      
      10uH inductor + 100n            01/01/70 00:00      
         No big time delay is allowed            01/01/70 00:00      
   Modified as per suggestions.            01/01/70 00:00      
      No Cap At SV1.            01/01/70 00:00      
         Voltage drops?            01/01/70 00:00      
            Drop only 0.16V*2=0.32V            01/01/70 00:00      
               F+5V ?            01/01/70 00:00      
                  Re: F+5V & F-5V            01/01/70 00:00      
                     Good, that I aksed...            01/01/70 00:00      
                        Re: What else need changes            01/01/70 00:00      
                        why r7 to avcc.            01/01/70 00:00      
                           Ok            01/01/70 00:00      
                              Re: Capacitor with LM336            01/01/70 00:00      
                              You could do...            01/01/70 00:00      
                                 re: you could do.            01/01/70 00:00      
                                    What I meant            01/01/70 00:00      
                                       re: what i meant.            01/01/70 00:00      
                                          Present layout            01/01/70 00:00      
                                             Additionally...            01/01/70 00:00      
                              How do i connect protection diode to AVc            01/01/70 00:00      
                                 Like D3            01/01/70 00:00      
                                    Why do I need a diode.            01/01/70 00:00      
                                       credit for design            01/01/70 00:00      
                                          Thanks!            01/01/70 00:00      
                                       From ADC7-input to AVCC            01/01/70 00:00      
         Is needed            01/01/70 00:00      
            Re: Cap needed.            01/01/70 00:00      
   Modified final layouts.            01/01/70 00:00      
   I fixed your layout            01/01/70 00:00      
      Looks nice...            01/01/70 00:00      
   Design sent for PCB making            01/01/70 00:00      

Back to Subject List