| ??? 11/05/05 06:56 Read: times |
#103309 - two layer PCB |
Hello All,
In two layer micro based PCB design can i have connected the GND net to Bottom layer copper pour. But i have doubt whether i could connect the Vcc (+5VDC) to Top layer copper pour. IF i do so will it give rise to any problem. The board also has +28VDC traces. +5VDC drives the Micro & SSR's. Coils use the +28VDC from the board Suresh. |
| Topic | Author | Date |
| two layer PCB | 01/01/70 00:00 | |
| +5VDC also drives PhotoMOS relays | 01/01/70 00:00 | |
| Solid ground plane is needed! | 01/01/70 00:00 | |
| what i have done is | 01/01/70 00:00 | |
| what you have done ... | 01/01/70 00:00 | |
| Thermal relief's | 01/01/70 00:00 | |
| You need a solid ground plane | 01/01/70 00:00 | |
| I want the best money can buy, but do no | 01/01/70 00:00 | |
| Thermal relief in PCB's | 01/01/70 00:00 | |
| An illustration... | 01/01/70 00:00 | |
| went through the design but | 01/01/70 00:00 | |
| Thermal reliefs were demonstrated | 01/01/70 00:00 | |
who are you posting to???? | 01/01/70 00:00 | |
| thermal reliefs only ease soldering | 01/01/70 00:00 | |
| Resistance calculation for thrmal relief | 01/01/70 00:00 | |
| you better read ..... | 01/01/70 00:00 |