Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
04/03/16 07:52
Read: times


 
#190644 - AT89LP Developer Studio
I installed and run without problem (on my old XP laptop) its version 2.3.1 (likely its last one).
After hours (exploring the menus and documents), I couldn't find the way to how to set the MCU crystal frequency.

Naturally, in this case, the debugger (via internal simulator for C51ASM or SDCC project) cannot provide the processor timing (total or relative) in cycles and/or micro-seconds.

Is it just me?

Thank you.

List of 8 messages in thread
TopicAuthorDate
AT89LP Developer Studio            01/01/70 00:00      
   AT89LP Developer Studio reports Cycles            01/01/70 00:00      
      (this and?) other chips            01/01/70 00:00      
         Thank you, Erik,            01/01/70 00:00      
         Cycle variations            01/01/70 00:00      
      Thank you, Jim            01/01/70 00:00      
         TSim51 Windows/Linux             01/01/70 00:00      
            Thank you again, Jim.            01/01/70 00:00      

Back to Subject List