| ??? 04/03/12 12:54 Read: times |
#186984 - Can work... Responding to: ???'s previous message |
... if the two wires to each solenoid are twisted, so that they do not create a relevant loop area. (Do you know, that you can buy solenoids with built-in free wheel diode?)
Take care, in your scheme the diodes are the wrong way round! The cathodes must go to 24VDC!! By the way, your signal ground isn't very proper. You should have a printed circuit board with solid ground plane. So, you should take a double sided board. Kai Klaas |
| Topic | Author | Date |
| Protection diode | 01/01/70 00:00 | |
| Catch diode | 01/01/70 00:00 | |
| PCB design is correct | 01/01/70 00:00 | |
| Diode connection | 01/01/70 00:00 | |
| Can work... | 01/01/70 00:00 | |
| can is a big word | 01/01/70 00:00 | |
| And resistors | 01/01/70 00:00 | |
| Can, will ... | 01/01/70 00:00 | |
| probabl;y, but | 01/01/70 00:00 | |
| Definitely room for improvements | 01/01/70 00:00 | |
| for our non-fluent friends | 01/01/70 00:00 | |
Yes - diodes as close to inductors as possible | 01/01/70 00:00 | |
| la cucaracha | 01/01/70 00:00 |