| ??? 10/27/10 13:05 Read: times |
#179366 - why do you care? Responding to: ???'s previous message |
Now, I want to make use of fixed baud rate 9600 for the same setup. I had tried with 3rd timer (Timer 2) of 8052, but failed.
For a master-slave that does not communicate with the outside, the baudrate can be anything, there is no need to use an 'authorized' baudrate. If you are absolutely stuck with these oscillator frequencies, just use the highest baudrate you can get. If you have to communicate with the outside, you must change form a 'processor crystal' to a "UART crystal" such as 11.592 Erik |
| Topic | Author | Date |
| Baud Rate using 6 Mhz Crystal | 01/01/70 00:00 | |
| you can't unless you have Timer2 | 01/01/70 00:00 | |
| 7.3728Mhz | 01/01/70 00:00 | |
| I think this file might help you. | 01/01/70 00:00 | |
| nice | 01/01/70 00:00 | |
| Keil's 8051 Baud Rate Calculator | 01/01/70 00:00 | |
| Timer 2 in Serial Comm Mode 3 | 01/01/70 00:00 | |
| why do you care? | 01/01/70 00:00 | |
| Missing Zero | 01/01/70 00:00 | |
close enough | 01/01/70 00:00 |