| ??? 03/30/10 16:25 Read: times |
#174645 - I2C protocol Responding to: ???'s previous message |
I've read about I2C protocol but i didnt understand much.
All i understood is i should create the pulse by sending a bit and then raise and lower the clock. Do it till byte is send and wait for ack bit. In datasheet it says The serial interface of the SHTxx is optimized for sensor readout and power consumption and is not compatible with I2C interfaces. Does it mean that I can't control the sensor without using MAX232? I cant run the part of code that controls the sensor in any simulator. |
| Topic | Author | Date |
| 8051 using i2c | 01/01/70 00:00 | |
| What was your result? | 01/01/70 00:00 | |
| Results | 01/01/70 00:00 | |
| Binary data or printable ASCII data? | 01/01/70 00:00 | |
| Binary data | 01/01/70 00:00 | |
| I probably have a problem using I2C protocol. | 01/01/70 00:00 | |
| I2C protocol | 01/01/70 00:00 | |
| that being the case | 01/01/70 00:00 | |
| So it clearly tells you that it is *not* I2C!! | 01/01/70 00:00 | |
| start over | 01/01/70 00:00 | |
| Why not start with the code they give you? | 01/01/70 00:00 | |
| what code? | 01/01/70 00:00 | |
| compile it | 01/01/70 00:00 | |
| You have to be prepared to do some work, you know | 01/01/70 00:00 | |
| Ripping assembler from the debugger | 01/01/70 00:00 | |
| I need some help | 01/01/70 00:00 | |
| Not a Contracting Site | 01/01/70 00:00 | |
| We may be able to come to an arrangement - on one condition | 01/01/70 00:00 | |
| BRAVO | 01/01/70 00:00 | |
| I need some help 2 | 01/01/70 00:00 | |
| Have you checked the debugger/simulator yet? | 01/01/70 00:00 | |
| Compiler/simulator | 01/01/70 00:00 | |
| No compiler in the C51 kit??? | 01/01/70 00:00 | |
you were so right | 01/01/70 00:00 |