| ??? 10/26/09 11:22 Read: times |
#170067 - How did you measure current ? Responding to: ???'s previous message |
Hello Mandar,
Just 1 question as said in subject, How did you measure this current? 1. At entery point of PCB on Vdd 2. At entery point of PCB on Gnd 3. At Gnd Pin of Micro. 4. At Vdd Pin of Micro. Or some other point? Regards, Mahesh |
| Topic | Author | Date |
| controller in total power down mode... | 01/01/70 00:00 | |
| Clock usually used to detect edges | 01/01/70 00:00 | |
| How do you mean? | 01/01/70 00:00 | |
| The datasheet tells you what is *guaranteed* to work | 01/01/70 00:00 | |
| What DataSheet says is... | 01/01/70 00:00 | |
| About Total powerdown mede: | 01/01/70 00:00 | |
| How did you measure current ? | 01/01/70 00:00 | |
| How did you measure current ? | 01/01/70 00:00 | |
current in total power down mode | 01/01/70 00:00 | |
| Pullup? | 01/01/70 00:00 |