| ??? 07/18/09 11:53 Read: times |
#167522 - AT89C5131 |
I have put the AT89C5131 in ISP mode..
I have install FLIP. Now i my laptop cannot recognise the AT89c5131 yet.. I follow the FLIP steps open the device manager and choose the directory to install the driver manually.. But, still my laptop cannot find a suitable driver for the USB.. wat should i do? the hardware conditions that i have done to put At89C5131 in ISP mode.. EA left unconnected. VDD=5V Vss connected to ground. Crystal=12Hz and two 22p capacitor for the XTAL1 and XTAL2 Pull reset and PSEN pin low at the same time. Release reset pin, then PSEN pin. then, immediately detach the Vref. |
| Topic | Author | Date |
| AT89C5131 | 01/01/70 00:00 | |
| are you using the ATMEL 'cable' made by Atmel or.... | 01/01/70 00:00 | |
| not using Atmel cable | 01/01/70 00:00 | |
| looking for a reason to use that term? | 01/01/70 00:00 | |
| Kitchen table programmer | 01/01/70 00:00 | |
| Cite ? | 01/01/70 00:00 | |
| Notes on Programming the Atmel USB 8051 | 01/01/70 00:00 | |
| Try 16MHz crystal | 01/01/70 00:00 | |
| not working | 01/01/70 00:00 | |
| set the BLJB | 01/01/70 00:00 | |
| CONGRATULATIONS | 01/01/70 00:00 | |
| API routines | 01/01/70 00:00 | |
API Routines | 01/01/70 00:00 |